Food Safety for Pork – Part 2

Continued from part 1…

QXD6Y5RRI2

Trichinosis parasite is no longer much of a threat in U.S. pork. All pork must be adequately cooked to eliminate disease-causing parasites and bacteria that may be present. Humans may contract trichinosis (caused by the parasite, Trichinella spiralis) or other foodborne illnesses by eating undercooked pork. However, much progress has been made in reducing trichinosis in grain-fed hogs and human cases have greatly declined since 1950. Because of modern feeding practices, trichinosis is a no longer of significant concern. Even if the parasite is present, it will be killed at 137° F. That’s well below the recommended consumer level end cooking temperature for pork, which is 160° F (home consumer cooking temps are always higher than the FDA Food Code for restaurants and food service).

FDA Food Code & Lower Pork Cooking Temperature—For commercial food service, pork can be cooked to safe lower minimum internal temperatures to maintain texture and taste.  Review the Food Code quotes for cooking raw animal foods including pork in Chapter 3, Part 4 at http://www.cfsan.fda.gov/~acrobat/fc05-3.pdf

• Whole cuts of raw pork, such as chops, pork ribs, or pork steak must be cooked to 145°F for 15 seconds.
• Whole pork roasts must be cooked to 145°F and held at that temperature for at least 3 minutes.
• With a combination of longer time and lower temperature, pork tenderloin roasts, whole cured ham roasts & other slow cooked pork roasts can be cooked to 130°F for at least 112 minutes (based on pork roast weight, oven air temperature, and humidity). There is a chart in Chapter 3 of the FDA Food Code for these recommendations.
• Ground raw pork, pork sausage, injected meats such as water added hams must be cooked to 155°F for 15 seconds.
• Stuffed pork chops or stuffed roasts and must be cooked to 165°F for 15 seconds.
• Leftover cooked pork must be cooked to 165°F for 15 seconds.
• Raw pork must be separated during storage, preparation, holding, and display. Use separate cutting boards and utensils in contact with all other animal species
• Cold holding for raw pork is 41°F of below. Colder than 41°F extends shelf life.
• Wash hands before and after handling any raw pork.

Irradiation (a form of cold pasteurization with safe radiation) has also been approved for use on pork by the Food and Drug Administration (FDA) and the USDA/FSIS in low-doses to control trichinella. Treated pork would not be sterile and would still need to be handled safely. Trichinella could be alive but would be unable to reproduce. Packages of irradiated pork must be labeled with the irradiation logo as well as the words “Treated with Irradiation” or “Treated by Irradiation” so they would be easily recognizable at the grocery store.

The OINK Quiz for Non-farmers & City Slickers:

1.) How many swine breeds are there in the U.S. today?

A) 8

B) 12

C) 15

2.) What is another name for a female swine?

A) Boars

B) Barrows

C) Gilts

3.) What do you call the offspring of a male and female swine?

A) piglet,

B) pig

C) Both A & B

4.) When a sow gives birth approx. how many babies are usually in the group?

A) 1-4

B) 8-12

C) 20-25

5.) When a pig is 6 month old and is “market weight” how much does it usually weigh?

A) 140 pounds

B) 250 pounds

C) 400 pounds

6.) What’s the heaviest hog ever recorded?

A) 800 pounds

B) 1500 pounds

C) 2500+ pounds

7.) Meats are graded by USDA for quality. How many “grades” of pork are there?

A) 2

B) 5

C) 10

The OINK Quiz Answers

1 — A. There are eight major swine breeds in the United States today: Duroc, Landrace, Chester White, Poland China, Berkshire, Spots, Yorkshire, and Hampshire.

2 — C. Female swine are called gilts. After a gilt has given birth, she is called a sow. Male swine are either boars or barrows. Boars are male swine that are capable of producing offspring. Barrows are male swine that have been neutered and are not capable of reproducing.

3 — C. The offspring of a boar and a sow is a piglet or pig. When a sow gives birth, it is called farrowing.

4 — B.  A sow gives birth to a group of 8-12 piglets, called a litter.

5 — B. When a pig is about 6-months old and at market weight (around 250 pounds), it is called a hog. Much of a hog is cured and made into ham, bacon and sausage. Uncured meat is called “fresh pork.”

6 — C. A Poland China hog named “Big Bill” weighing 2,552 pounds and measuring 9 feet long with a belly that dragged the ground was owned by Burford Butler of Jackson, Tennessee, in 1933. That’s some bacon!

7 — A. USDA grades for pork quality reflect only two levels: “Acceptable” grade and “Utility” grade. Pork sold as Acceptable quality pork is the only fresh pork sold in supermarkets and restaurants. It should have a high proportion of lean meat to fat and bone and the lean meat should be grayish pink and firm with fine marbling. Pork graded as Utility is mainly used in processed products and is not available in supermarkets for consumers to purchase. Yield grades may be assigned as U.S. No. 1, 2, 3, 4 or Utility. U.S. yield grade No. 1 is the highest grade a carcass can receive and is based on the yield of the four lean cuts including Ham, Loin, Blade shoulder and arm shoulder. The more muscle and less fat, the more useable, fresh pork can be sold from the carcass. Unacceptable lean meat quality, includes dark red lean meat, soft and oily fat, or bellies too thin for bacon production, are given a U. S. Utility grade.
Bottom Line: So what does the quiz have to do with food safety? Not so much, but good for your food knowledge trivia. Enjoy that safely prepared hot dog, Iowa chop, barbeque pork, ham sandwich, or pork tenderloin.

***

About the Author: Lacie Thrall

Lacie Thrall PictureLacie Thrall passed away in early 2017 after a long illness. She dedicated her 35-year career to improving the health and well-being of others by promoting food safety best practices. Lacie worked in environmental health for 17 years before joining FoodHandler in 1997 as the Director of Safety Management. While at FoodHandler, she trained employees and customers on safe food handling practices, including proper hand hygiene and glove use. Later as a FoodHandler consultant, Lacie provided the foodservice industry with food safety information and advice through her blog on FoodHandler.com.

This information is provided as a general guideline and is not intended to be, nor does it, constitute legal or regulatory advice. Additional Federal regulations may apply to your particular circumstances. State, regional and local laws, ordinances and regulations may also apply. Quiz source: www.pork.org

Meat Color and Doneness: Persistent Pinking

Late in June, my family and I were able to visit the Black Hills, an area of the country in which I have not had the opportunity to spend much time.  One evening, as we dined at a local restaurant, I observed a table across the dining room sending back a dinner.  While I couldn’t hear the entire conversation and I certainly wasn’t trying to eavesdrop, it was apparent that the customer was unhappy with the cooking of their hamburger and was sending it back because it was too pink in the middle.  That immediately brought to my mind the phenomenon known as persistent pinking.  A term I became familiar with because of work done by some colleagues here at Kansas State, which they present each summer to a group of foodservice operators who join us on-campus for an in-depth week-long look at all things food safety.

Quat Binding – Why this Can Have a Disastrous Impact on Your Sanitation Program.

In June, I had the opportunity to represent FoodHandler and speak on food safety behavior for customers of Martin Bros. Distributing in Waterloo, Iowa.  One of the questions that was asked caught me a little off guard. The question was about quat binding.  It caught me off guard not because it was a bad question, but only because it was not something I had previously been asked nor had not yet been exposed to the phenomenon. However, I soon learned that in certain jurisdictions, it is resulting in changes to how sanitizing cloths are to be stored in sanitizing buckets (or not) in the foodservice industry. When I returned home from the trip, I had to dig into it to learn about what quat binding is and how it might impact foodservice operations.

Are Grades for Foodservice Inspections a Good Idea?

I generally try to stay away from controversial topics in my blog, but this is one I thought it might be interesting to discuss. Occasionally on my travels, I will come across a state or a local jurisdiction that requires foodservice inspection scores be posted in the window of the establishment.  The idea is to allow would-be customers the ability to see how the foodservice operation in which they are about to eat scored on their latest health inspection.